While nearly any peptide can gel under the right conditions, some are well-known for their gelling tendencies. Here’s a list of the usual suspects:

1. AOD-9604
Probably the most infamous of all — AOD tends to form a thick, stringy gel if not handled carefully. This one is very hydrophobic and sensitive to temperature and concentration.

2. GHK-Cu
Copper-bound peptides like GHK-Cu can form gels or crystals depending on the solvent used and the ambient pH. Copper itself doesn’t help the solubility much.

3. Thymosin Beta-4 (TB-500)
While this one often dissolves well at lower concentrations, it can develop a gel-like consistency if overdosed into a small volume of liquid.

4. Melanotan II

Known for being finicky, MT2 can clump or gel, especially if it’s cold when reconstituted or the water is added too quickly.

5. CJC-1295 (DAC and non-DAC)

This longer peptide sometimes forms viscous solutions, especially when not given time to dissolve fully. It benefits from warm temps and slow mixing.

6. BPC-157

BPC usually dissolves well, but under some conditions (like high concentration or cold storage), it may start to gel or form strands.

7. IGF-1 LR3

This is more rare, but at high concentrations or if pH is off, this growth factor can aggregate and become cloudy or sticky.

8. Epitalon

A short peptide, but still known to occasionally form light gels — especially if the reconstitution environment is less than ideal.

9. Selank / Semax Variants

These nootropic peptides are usually stable but have been reported to gel when compounded at higher concentrations or exposed to rapid temperature changes.

If you’re dealing with a gelling peptide, here are a few simple tips that can help bring it back into proper solution:

1. Warm the vial gently

Let the vial come to room temperature before reconstituting. If needed, place it in a warm (not hot!) water bath for a few minutes to loosen things up.

2. Add your solvent slowly

Instead of blasting bacteriostatic water into the vial, let it drip slowly down the side. This allows the peptide to dissolve gradually and reduces shock to the material.

3. Swirl, don’t shake

Shaking creates bubbles and doesn’t help dissolve aggregates. A gentle swirl or rolling the vial between your hands is more effective.

4. Let it sit

Sometimes the peptide just needs time. Let it rest after adding solvent, then check back in 10–15 minutes and gently swirl again.

5. Try an alternate solvent

If the peptide still doesn’t dissolve, small amounts of 0.6% acetic acid or even DMSO (for research use only) can help break up stubborn hydrophobic clumps.

6. Dilute further if needed

If you’re working with a very high concentration, it may be helpful to use a larger volume of solvent to encourage full dissolution.

Peptide gelling is not a quality issue, nor is it a manufacturing problem — it’s simply a result of biochemical properties interacting with water and environment. Hydrophobic sequences, high concentrations, or quick handling can all lead to temporary clumping or gel formation.

With a little patience and the right technique, almost all gelling issues can be reversed or avoided. If you work with these peptides regularly, getting familiar with their personalities — and knowing how to coax them into solution — will save you time and frustration.
So next time your peptide gels, just remember: it’s not broken — it’s just being dramatic.

Reach out to us any time — we’ve seen it all (and then some). If you tried all the required steps, we will further help you by contacting us.

[email protected]